Feed Performance Computing Form

Values of the displayed performance graph and performance table
may not be satisfied due to the load on the feeder due to material stress etc.

Input basic conditions ...

Model :

Material Weight [kg] : , , ,

Please enter in the range of 0~35.

Select the horizontal axis of the performance graph.

Press Speed

Feed Angle [deg] : , , ,

Please enter in the range of 1~300.

Press Speed [spm] : ~

*Specify the range to be displayed.

Display priority parameter :Feed AngleMaterial Weight

Feedable Time

Feedable Time [ms] : ~

*Specify the range to be displayed.

Press Speed [spm] : , ,

Please enter in the range of 1~200.

When "Feeding time" is selected, the display priority parameter is "Fixed material weight".

Enter optional conditions ...

Comparative Model :

Target Feed Length [mm] :

Model R20/R30/R40/R50 Specifications

Max. Press Rotational Speed [spm]	200
Max. Feed Speed [mm/s]	1256

Model R20/R30/R40/R50 at 200spm

The actual release start / end timing does not match the input signal. Timing will change due to adjustment of air pressure, pressurized spring load, release stroke amount, etc.
The input signal should continue for a period longer than the angle shown in green on the graph. The standard value of the product is displayed, and when you change the noise filter strength, the value will be different.
Because the actual operation time varies greatly depending on usage conditions, only the minimum time constraint of the above input signal is displayed. In consideration of the delay time of the release end, a margin is required until the feed start timing.

Chart Manipulation Method

X Axis : Logarithmic Linear
Y Axis : Logarithmic Linear

FeedAngle:150°

FeedAngle:180°

FeedAngle:210°

Row Step Value

FeedAngle:150°

FeedAngle:180°

FeedAngle:210°

・Percent(%)：The value of Accel or Speed at the maximum feed length is displayed.